Latency: Less than 1ms
This tiny, power-packed module takes in a VGA or Component signal (depending on the version) and outputs an HDMI 1.3 signal with an embedded analog or SPDIF audio front-end for use in your smallest of projects. This design is a higher quality, smaller, and more efficient version of the widely available Wii2HDMI modules and VGA2HDMI modules that are available online. If you are not happy with those modules, then you will absolutely be happy with these. The RGB VGA module can accept any resolution from VGA to UXGA and does not provide any internal scaling of the image. The Component module can accept any resolution video signal up to 1080p60 and does not provide any internal scaling of the image.
This board can take in either SPDIF or analog audio. The SPDIF audio format can be Dolby 5.1 Surround Sound and it is embedded over the video output for use with any surround sound system connected to your TV.
This device typically consumes <300mA in all use cases; however, you should test this design in your system before designing a specific regulator.
- Supports 480i/p, 576i/p, 720p25/30/50/60, 1080i50/60, 1080p24/25/30/50/60.
- Supports RGB graphics from VGA to UXGA
Please be aware that these boards contain components that are sensitive to ESD strikes. Be sure to handle these using proper ESD handling techniques.
All company, brand, and product names are trademarks or registered trademarks of their respective holders. Electron Shepherd LLC has no affiliation to, is not associated or sponsored by, and has no express rights to third-party trademarks. The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing LLC in the Untied States and other countries.
Latency
We used a Time Sleuth to measure the latency that the Analog2HDMI module adds during its analog-to-digital conversion.
All measurements were done with a 7" Loncevon HDMI monitor with the Time Sleuth output resolution set to 1080p @ 60Hz.
